MANNOL 9995 / 9996 DPF Regenerator & Flush Fluid
Professional DPF Cleaning System

MANNOL 9995 / 9996 DPF Regenerator & Flush Fluid

Professional two-stage DPF cleaning system for restoring diesel particulate filter efficiency without dismantling the filter.

$104.65
SKU: AD9995/9996
✓Two-Stage DPF Cleaning System
✓DPF Regenerator + Flush Fluid
✓No DPF Dismantling Required
✓For Naturally Aspirated & Turbo Diesel
Fast Shipping Secure Checkout Professional Grade
🔥

DPF REGENERATION SUPPORT

9995 DPF Regenerator helps start particulate filter regeneration and promotes the burning of accumulated soot.

🫧

TWO-STAGE CLEANING SYSTEM

9995 dissolves accumulated contamination while 9996 Flush Fluid washes out the dissolved residues.

⚙️

RESTORES FILTER CAPACITY

Helps restore DPF capacity and reduce hydrodynamic resistance of the particulate filter.

🛡️

LOW-ASH FORMULA

Neutral low-ash formulation evaporates without leaving residue inside the filter.

i

Product Information

DPF Regenerator & Flush Fluid – a professional set of tools for gentle cleaning and restoring the efficiency of diesel particulate filters (DPF) without dismantling them. Suitable for all diesel engines, both naturally aspirated and turbocharged, equipped with these systems. Applicable for diesel engines equipped and not equipped with automatic regeneration systems for diesel particulate filters. Suitable for all DPF's. The product is applied to the particulate filter using a sprayer with a compressor.

Properties:

• 9995 DPF Regenerator starts the process of regeneration of the particulate filter. Promotes complete burning of the accumulated soot, loosening it and acting as a combustion catalyst. Dissolves and removes unburned dirt from the pores of the particulate filter;
• Especially effective for vehicles operating in urban mode and in the cold season;
• Restores the full capacity of the particulate filter, and the 9996 DPF Flush Fluid washes out all the dissolved residues of the 9995 DPF Regenerator;
• Restores the original engine power by reducing the hydrodynamic resistance of the filter. Save fuel;
• Neutral low-ash formula. It evaporates without a trace and is removed from the filter.
• Extends the service life of the particulate filter and reduces the cost of operating the car. Regular use may eliminate the need to replace the DPF altogether;
• Reduces the toxicity of exhaust gases.
1. Stage with the use of DPF Regenerator 9995: Stop the engine. Cool the diesel particulate filter to less than 40 °C. Pour the entire amount of the product into the spray container. Remove one of the particulate filter sensors (pressure or temperature). Insert the spray gun into the orifice. Spray the entire volume of the product into the particulate filter at a pressure of 4 BAR. Leave to act for 20 minutes. Replace the sensor. Place the container under the exhaust pipe to collect dirt. Turn on the engine and let it run at high speed (approximately 3000 rpm) for 5 minutes, while the exhaust pipe may leak dirty black liquid.
Stop the engine. Cool the diesel particulate filter to less than 40 °C.
2. Stage with application of washing liquid 9996 DPF Flush Fluid: Pour the entire amount of the product into the spray container. Remove one of the particulate filter sensors (pressure or temperature). Insert the spray gun into the orifice. Spray the entire volume of the product in the direction of the particulate filter at a pressure of 4 BAR. Leave to act for 1-2 minutes. Insert the sensor into place. Turn on the engine and let it run at 2000 – 2500 rpm for 5 to 15 minutes until the product completely evaporates from the filter. During the cleaning process, foam flakes may escape from the exhaust pipe. Stopping the foam output indicates complete evaporation of the product.
After cleaning is complete, you need to drive for 20-30 minutes on a flat road with an engine speed of about 3000 rpm (it is allowed to let the engine idle for 20-30 minutes with a warm-up to the operating temperature). After that, for the best effect, start the process of forced (manual) regeneration of the particulate filter in accordance with the instructions of the car manufacturer.
To keep the particulate filter clean, use the 9994 MANNOL DPF Filter Cleaner in the future between service periods.
Documents

Technical Downloads

1 file
PDF 99959996_TDS.pdf Technical Data Sheet (TDS)
Perfect For
🚗
DIESEL VEHICLES Suitable for diesel engines equipped with diesel particulate filters.
🌬️
TURBO & NATURALLY ASPIRATED Suitable for both naturally aspirated and turbocharged diesel engines.
🏙️
URBAN DRIVING Especially effective for vehicles frequently operated in urban driving conditions.
❄️
COLD-SEASON OPERATION Suitable for DPF cleaning where soot accumulation is increased during cold-season use.
🫧
TWO-STAGE DPF CLEANINGCombines DPF regeneration and flushing for thorough particulate filter cleaning.
🔥
REGENERATION SUPPORTHelps promote soot combustion and restore particulate filter efficiency.
⚙️
NO DISMANTLINGDesigned to clean the DPF without removing the particulate filter.
🛡️
LOW-ASH FORMULANeutral formulation evaporates without leaving residue in the filter.

Professional Two-Stage Cleaning for Diesel Particulate Filters

MANNOL 9995 / 9996 DPF Regenerator & Flush Fluid provides a professional two-stage cleaning process that helps dissolve soot and contamination, flush away residues and restore diesel particulate filter efficiency without dismantling the DPF.